Device Driver(s) for various motor and lighting (LED) control products have been created by various contributors to Control 4. When these drivers are available, links to download locations will be provided. In the interim. Note, device drivers can be written by Control 4 authorized dealers by utilizing the technical manual found within the Programming Kits section on this site. In some cases, you may find applicable drivers/profiles under "Local Download" below. These files are provided as a convenience to out dealers and are soley provided "AS IS" and without any support.
When downloading files, remember to unzip before using.
| Model |
Functions |
Sample Screens / Downloads |
IMC-100 (via IBT-100 serial interface)
Single Motor Controllers
|
Controls device(s) using RS-232-C communication.
Controls motor direction (up,down, and stop).
Controls intermediate presets (IMC-100T).
Controls multipe zone, group, and node (Z.G.N) addresses.
|
Integration Notes
Module-Control4 Site
[Date Code:see C4 site]
Local Download-CSI Site
Sample C4 Project (within driver package)
|
ILC-100 (via IBT-100 serial interface)
LED Lighting Controller
|
Controls device(s) using RS-232-C communication.
Controls lighting state (ON/OFF).
Controls lighting presets (P1-P8).
Controls lighting effects (Effect #1).
Controls multipe zone, group, and node (Z.G.N) addresses.
Controls setup, dissolve rate and sequence rate.
|
Integration Notes
Module-Control4 Site
[Date Code: see C4 site]
Local Download-CSI Site
Sample C4 Project (within driver package)
|
IMC-100 (via eNode-Ethernet Adapter)
Single Motor Controllers
|
Controls device(s) using UDP communication over Ethernet.
Controls motor direction (up,down, and stop).
Controls intermediate presets.
Controls multipe zone, group, and node (Z.G.N) addresses.
Controls setup, browse, and help menus.
|
Integration Notes
Module-Control4 Site
[Date Code: see C4 site
Local Download-CSI Site
Sample C4 Project (within driver package)
|
|
ILC-100 (via eNode Ethernet Adapter)
LED Lighting Controller
|
Controls device(s) using UDP communication over Ethernet.
Controls lighting state (ON/OFF).
Controls lighting presets (P1-P8).
Controls lighting effects (Effect #1).
Controls multipe zone, group, and node (Z.G.N) addresses.
Controls setup, dissolve rate and sequence rate.
|
Integration Notes
Module-Control4 Site
[Date Code: see C4 site]
Local Download-CSI Site
Sample C4 Project (within driver package)
|
|
BRIC (via built-in serial interface)
Single (or dual) BRIC system
|
Controls device using built-in RS-232-C communication.
Controls two separate motor digitally with up, down,and stop controls.
Controls third motor (traditionally a door motor) with up and down controls.
Controls multipe BRIC addresses (unit 1-4).
Controls up to 8 preset multi-motor presets.
|
Integration Notes
Module-Control4 Site
[Date Code: see C4]
Local Download-CSI Site
Sample C4 Project (within driver package)
|
|
BRIC (via external e-Node adapter)
Single (or dual) BRIC systems
|
Controls device using external e-Node connected to (Master) BRIC's built-in RS-232-C port.
Controls two separate motor digitally with up, down,and stop controls.
Controls third motor (traditionally a door motor) with up and down controls.
Controls multipe BRIC addresses (unit 1-4).
Controls up to 8 (24?) preset multi-motor presets.
|
Integration Notes
Module-Control4 Site
[Date Code: TBD]
Local Download-CSI Site
Sample C4 Project (within driver package)
|
