IQA-eNode™ Pilot Application

Ethernet application Software for CS-Bus Control

CS-Bus Commissioning Software

Easy to use application software customized for remote commissioning from one to 65,000 CS-Bus peripherals located on the CS-Bus. This robust application has been field tested within some of the largest campus and high-rise building settings in the world where thousands of CS-Bus peripherals have been successfully commissioned.

Enables Testing of any CS-Bus Component

A command window allows specific device commands to be tested on any number of CS-Bus compatible peripherals ranging from a single unit to entire system using the Zone/Group/Node (ZGN) addressing scheme or a Unique Identifier Device (UID) scheme.

Enables Prototyping of Network Operation of CS-Bus peripherals

Typically in large buildings, a building management system (BMS) is used to manage all life support systems, HVAC systems, as well as communication, security, lighting and other control systems. The eNode Pilot application can be used to test all functions of operation of CS-Bus peripherals prior to the BMS system going on line. This is particularly valuable when a BMS system cannot be turned off for off-line experimentation and testing.

Generate a Network Map of all CS-Bus Networked Devices

A graphical user interface enables a pictorial representation to be viewed and printed, or archived showing all identified CS-Bus peripherals. Those peripherals can be given alias names for easy management. In addition, IP addresses, UID address, peripheral priority and classification as well as a accurate time stamp for all traffic data are available in report format

Verify Key Parameters of All Installed CS-Bus equipment on the bus

Key to managing a large network of clients (devices on the CS-Bus), is the requirement to be able to monitor hardware and firmware versions as well as unique programming specific to all devices on the network. The Pilot Application is the choice of professionals for managing and monitoring this information.