Integration Partner Modules-Elan Home Systems
VIA System (legacy)
Device Driver(s) for various motor and lighting (LED) control products are currently available below as sample one-way drivers. These drivers may be imported into an active project using Elan G! Tools. Once imported as a Generic Serial driver, they can be used two ways.
Serial Driver. To create a new serial driver, first establish a new communications device and set appropriate baud rates for the IBT-100 (serial interface manufactured by Converging Systems for this purpose). Then import from file the approrpriate Generic Serial Driver and set the baud rate (19.2k ,n,8,1, no).
Ethernet Driver. N/A
Notes: Device Driver(s) for various motor and lighting (LED) control products are currently available below as sample one-way drivers. These drivers may be used with the appropriate RS-232c adapter (IBT-100) or and built-in RS-232c functionality that may exist with certain products..
| Model |
Functions |
Sample Screens / Downloads |
IMC-100 (via IBT-100 serial interface)
Single Motor Controllers
|
Controls device(s) using RS-232-C communication.
Controls motor direction (up,down, and stop).
Controls intermediate presets (IMC-100T).
Controls multipe zone, group, and node (Z.G.N) addresses.
Controls setup, browse, and help menus.
|
Integration Notes
Module (1 K)
[Date Code: 07/25/2010]
Templates (3 K)
|
ILC-100 (via IBT-100 serial interface)
LED Lighting Controller
|
Controls device(s) using RS-232-C communication.
Controls lighting state (ON/OFF).
Controls lighting presets (P1-P8).
Controls lighting effects (Effect #1).
Controls multipe zone, group, and node (Z.G.N) addresses.
Controls setup, dissolve rate and sequence rate.
|
Integration Notes
Module (2 K)
[Date Code: 07/25/2010]
Templates (5 K)
|
IMC-100 (via eNode-Ethernet Adapter)
Single Motor Controllers
|
Controls device(s) using UDP communication over Ethernet.
Controls motor direction (up,down, and stop).
Controls intermediate presets.
Controls multipe zone, group, and node (Z.G.N) addresses.
Controls setup, browse, and help menus.
|
Integration Notes
Module (1 K)
[Date Code: 07/25/2010]
Templates 32 K)
|
|
ILC-100 (via eNode Ethernet Adapter)
LED Lighting Controller
|
Controls device(s) using UDP communication over Ethernet.
Controls lighting state (ON/OFF).
Controls lighting presets (P1-P8).
Controls lighting effects (Effect #1).
Controls multipe zone, group, and node (Z.G.N) addresses.
Controls setup, dissolve rate and sequence rate.
|
Integration Notes
Module (2 K)
[Date Code: 07/25/2010]
Templates (5 K)
|
|
BRIC (via built-in serial interface)
3-motor Master Controller System
|
Controls device using built-in RS-232-C communication.
Utilizes Elan Built-in 1-way wizard available in Via Tools.
Controls two separate motor digitally with up, down,and stop controls.
Controls third motor (traditionally a door motor) with up and down controls.
Controls multipe BRIC addresses (unit 1-4).
Controls up to 8 preset multi-motor presets.
|
Integration Notes
Module (TBD K)
[Date Code: Current]
Templates (3 K)
|
|
